Advance Adapters 712502 User Manual
Advance Adapters For the car
ADVANCE ADAPTERS INC.
P/N: 712502
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 3
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
04-30-02
KIT CONSISTS OF:
No.
Qty
Part No.
Description
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
OPTIONAL ITEMS:
Qty
Part No.
Description
1.
1
711502
ADAPTER CASTING
2.
1
716011
BEARING RETAINER (JEEP #941665)
3.
1
716171
PILOT BEARING (.629" I.D.)
4.
1
716706
NATIONAL SEAL #482208
5.
4
725016
S.H.C.S. 1/2"-13 x 1-1/2" LONG
6.
1
JP001
JEEP INSTRUCTION MANUAL
1
716185
CLUTCH REL. ARM
INSTALLATION INSTRUCTIONS:
When replacing a 4 cylinder engine, a new transmission input shaft, Advance Adapter Part No. 716014, will be required.
A new cluster gear, Part No. 716018, is required when replacing a 16 tooth input shaft. Most conversions will require
the transfer case to be moved forward in order to obtain a good engine position. This will require driveshaft
modifications. The engine should be offset towards the driver's side by approximately 1" in order to allow for driveshaft
and starter motor clearance.
1.
Install pilot bushing into the engine crank shaft.
2.
Install seal into the new bearing retainer with the open side towards the transmission. Use the existing bolts that
were originally used for the stock retainer to mount the new retainer onto the T90 transmission.
3.
The following Chevy or Buick parts will be necessary:
Clutch Release Bearing
Clutch Release Lever
Pressure Plate
Clutch Disc with 1-1/8"-10
Flywheel
Bellhousing with small index diameter of 4.686"
4.
Bolt the adapter plate to the new bellhousing using the new bolts supplied.
5.
Bolt the transmission to the adapter plate using the original bolts.
JEEP T90 3 SPEED TRANSMISSION TO
CHEVY & BUICK ENGINES