Advance Adapters 712512 - Manual

ADVANCE ADAPTERS INC. P/N: 712512
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-05-12
KIT CONSISTS OF:
No. Qty Part No. Description
OPTIONAL ITEMS:
Qty Part No. Description
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals
are normally available at automotive dealerships and parts stores.
1. 1 711511 ADAPTER CASTING
2. 1 716016 TRANSMISSION INPUT SHAFT (T18 -17Tooth)
3. 1 716046 BEARING RETAINER
4. 1 716148 PILOT BEARING
5. 1 716724 NATIONAL SEAL #473203
6. 4 723137 S.H.C.S. 5/16"-18 x 7/8"
7. 2 724307 H.H.C.S 7/16"-14 x 1"
8. 2 725010 H.H.C.S. 1/2"-13 x 2" LONG
9. 1 725013 S.H.C.S. 1/2"-13 x 2" LONG
10. 1 725026 F.H.C.S. 1/2"-13 x 1-1/4" LONG
11. 1 JP001 JEEP INSTRUCTION MANUAL
JEEP T18 4 SPEED TRANSMISSION
TO CHEVY & BUICK ENGINES
INSTALLATION INSTRUCTIONS:
When converting this Jeep 4 speed transmission, you must change the transmission input shaft to the new style that
has been furnished in this kit.
If this kit is being used on a T18 transmission, then the stock needle bearings will be retained. The T18 transmission
also used two sizes of shifter synchronizer rings. If the transmission you have has a synchronizer ring that is too large,
you will then be required to purchase P/N T87-D14 from your Border Auto Parts 619-461-0171.
1. Install new shaft.
2. Install pilot bushing into the engine crank shaft.
3. Elongate the top two holes in the transmission case to match the top two holes in the adapter plate.
4. Bolt the bearing retainer to the adapter plate using the 4 bolts supplied.
5. Install the new oil seal with the open side towards the transmission.
6. Place the adapter plate to the bellhousing. Apply RTV silicone to the adapter plate and then index the transmission
into the adapter. New bolts have been provided to go through both the transmission and adapter plate and thread
into the new bellhousing.
7. The following parts will be necessary:
Clutch Release Bearing
Clutch Release Lever
Pressure Plate
Clutch Disc with 1-1/16"-10 spline
Flywheel
Bellhousing with small index diameter of 4.686"
1 716176 CLUTCH REL. ARM