Advance Adapters 712505 User Manual
Advance Adapters For the car
ADVANCE ADAPTERS INC.
P/N: 712505
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 2
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
06-25-07
KIT CONSISTS OF:
No.
Qty
Part No.
Description
OPTIONAL ITEMS:
Qty
Part No.
Description
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
1
716177
CLUTCH REL. ARM
1
716011
T90 RETAINER
1
716014
T90 INPUT SHAFT
INSTALLATION INSTRUCTIONS:
When replacing a 4 cylinder engine, a new transmission input shaft, Advance Adapter Part No. 716014, will be required.
A new cluster gear, Part No. 716018, is required when replacing a 16 tooth input shaft. Most conversions will require
the transfer case to be moved forward in order to obtain a good engine position. This will require driveshaft
modifications. The engine should be offset towards the driver's side by approximately 1" in order to allow for driveshaft
and starter motor clearance.
1.
Install pilot bushing into the engine crank shaft.
2.
Remove the bearing retainer from the front of the 3 speed transmission and cut the snout off as illustrated to an
overall length of
1-5/8". Remove the seal and install the new seal provided with the kit. The seal must have the
open side towards the transmission.
3.
The following Ford parts will be necessary:
Clutch Release Bearing
Clutch Release Lever
Pressure Plate
Clutch Disc with 1-1/8"-10
Flywheel
Bellhousing with small index diameter of 4.848"
4.
Bolt the new bearing retainer to the front of the adapter housing using the 4 bolts supplied.
5.
Bolt the adapter plate to the new bellhousing. The bellhousing must be from a 1965 or newer Ford engine. Early
model bellhousings are not applicable for use with this kit.
6.
Bolt the transmission to the adapter plate using the original bolts.
JEEP T90 3 SPEED TRANSMISSION TO
FORD V8 ENGINES 1965 & UP
1.
1
711504
ADAPTER CASTING
2.
1
716172
PILOT BUSHING (.625" I.D.)
3.
1
716706
NATIONAL SEAL #482208
4.
4
723119
S.H.C.S. 5/16"-18 x 1-1/4" LONG
5.
1
761019
BEARING RETAINER
6.
1
JP001
JEEP INSTRUCTION MANUAL
When replacing a 4 cylinder, it is necessary to
purchase the 716014 Input shaft & the 716011
Retainer.