beautypg.com

Advance Adapters 712543 User Manual

Ax15 to ford v8 adapter, Kit consists of

background image

KIT CONSISTS OF:

No.

Qty

Part No.

Description

ADVANCE ADAPTERS INC.

P/N: 712543

P.O. Box 247, 4320 Aerotech Center Way

New Item: (7/99)

Paso Robles, CA 93447

PAGE 1 OF 3

Telephone: (800) 350-2223

Fax: (805) 238-4201

Page Rev. Date:

09-09-11

OPTIONAL NOTES:

Wrangler & TJ's

If you have a master cylinder
that has a pin retaining the hose
assembly (pin type), you will need

Advance Adapters Part # 716130
or 716130TJ

(Identify which fit-

ting you will need - shown be-
low)

.

This fitting goes on your

master cylinder and gives you a
#3 male flare fitting to couple to.
We also offer a new braided stain-
less steel hose with #3 fittings
on both ends. This hose is

P/N#

716130H.

1.

1

711543

ADAPTER PLATE

2.

1

716122

.750 PILOT BUSHING FOR LATE MODEL AX15

3.

1

716124

BRASS FITTING

4.

1

716153

.590 PILOT BUSHING FOR EARLY MODEL AX15

5.

1

716742

RETAINER SEAL

6.

9

720030

TRANSMISSION BOLTS - S.H.C.S.10mm x 1.25 x 40mm

7.

8

720040

RETAINER BOLTS - S.H.C.S. 8mm x 1.25 x 20mm

8.

4

723113

RETAINER BOLTS - S.H.C.S. 5/16"-18 x 7/8"

9.

4

724317

S.H.C.S. 7/16"-14 x 1-1/4" BOLTS

10.

1

761019

BEARING RETAINER - FORD 4.848"

NOTES:

This kit fits both the internal & external clutch release mechanisms on AX15 transmissions.

The F150 bellhousings from 1987-88 trucks should be used to best accommodate the new hydraulic clutch system.
Z & M Manufacturing offers a special slave cylinder bracket to assist in the installation of these bellhousings. The
Z & M bracket provides the adequate clearance for the Ford exhaust system.

Z & M's phone number is (408)-274-9011.

To fit the F150 truck slave cylinder to the Jeep master cylinder, we have included a brass fitting that, when installed
on your slave cylinder, provides a #3 male fitting. We offer a new stainless steel braided hose (

P/N #716130H

)

that will couple your slave cylinder to your master cylinder. You can also purchase a generic hose assembly at
your local auto parts store. (See Optional Note above for YJ & TJ master cylinders).

CAUTION:
The input shaft pilot tip must be shortened 1/4"
to avoid bottoming out in the Ford crank.

AX15 TO FORD V8 ADAPTER

SPECIAL NOTE:

The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications

to any of the components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be
required to complete your conversion, we strongly recommend that you contact our sales department for more information. This instruction sheet
is only to be used for the assembly of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained
for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and parts
stores.

716130

716130TJ