Apple Workgroup Server 6150/66 - Manual (Page 22)

m If your monitor’s screen is larger than 17 inches measured diagonally, place it
next to the server (a monitor of this size is too heavy to sit directly on the
server’s case).
m Consult “Arranging Your Office” in Appendix A for suggestions about
locating your server equipment.
2 Connect the monitor’s power cord to the monitor.
On some monitors, the cord is already attached.
3 Plug in the monitor’s power cord.
Some power cords are designed to plug into the back of your server. You can also
plug the power cord into a grounded electrical outlet (an adapter may be needed).
Note: If you have an Apple AudioVision monitor, plug the monitor’s power
cord into the back of the server, not into an outlet.
Some monitors have to be connected to a grounded electrical outlet, not to the
server’s power socket. Check the information that came with the monitor.
After you plug in your monitor’s power cord, you need to connect the monitor
cable, as described in the next section.
Monitor power socket
Monitor power cord Monitor cable
6 Chapter 1 / Setting Up Your Server