Apple Workgroup Server 6150/66 - Manual (Page 21)

Installing an expansion card
If you purchased an expansion card for your server, install it now (see
“Installing an Expansion Card” in Chapter 3 for instructions). If you don’t
have an expansion card, go on to the next section, “Connecting a Monitor.”
Connecting a monitor
Your server has one high-density monitor port that accepts a monitor with a
screen 16 inches or smaller (measured diagonally).
Note: You can use a larger monitor by installing a monitor card. See
“Installing an Expansion Card” in Chapter 3.
You can connect many types of monitors to your server, including:
m Most standard monitors. See the Technical Information booklet that came
with your server for a more detailed list. To connect a standard monitor, you
must use the monitor cable adapter supplied with your server.
m Apple AudioVision monitors. AudioVision monitors include built-in
speakers, a microphone, video, and an Apple Desktop Bus (ADB) port
(for an input device such as a keyboard).
This section contains instructions for connecting either kind of monitor. To
connect a monitor from a manufacturer other than Apple, refer also to the
instructions that came with the monitor.
Connecting the monitor’s power cord
Monitors have two cords to connect: a power cord and a monitor cable. To
connect the monitor power cord:
1 Place the monitor on top of or next to the server.
Keep in mind these considerations:
m Allow a few inches for air circulation around the server and monitor.
m Make sure the top of the screen is slightly below eye level when you’re
sitting at the keyboard.
m Position the monitor to minimize glare and reflections on the screen from
overhead lights and windows.
Connecting a monitor 5