Apple Power Macintosh 9600 - Manual (Page 108)

2 If necessary, disconnect the two connectors to completely remove the speaker
housing/card guide assembly.
3 Insert the PCI card into the slot. Press the card gently but firmly until the connector is
fully inserted.
m Don’t rock the card side to side; instead, press the card straight into the
slot. (Rocking the card can damage the PCI slot.)
m Don’t force the card. If you meet a lot of resistance, pull the card out and
try again.
m To see if the card is properly connected, pull it gently. If it resists and stays
in place, it’s connected. (Make sure you don’t pull the card so much that
you accidentally disconnect it.)
Speaker housing/card guide assembly If you need to
completely remove the
speaker housing/card guide
assembly in order to insert the card, then disconnect these two connectors on the main logic
board and completely remove the assembly. There is a cluster of three connectors in this area.
Disconnect the outer two. They are the connectors for the fan and the speaker.
108 Chapter 8