AEM Infinity Supported Applications - Mitsubishi 2006 Evolution IX Engine - Manual (Page 20)

20
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware
Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest.
Pin
Evo
VIII
Dest.
Pin
Evo IX
Hardware Specification Notes
C2-44 LowsideSwitch_7 Spare GPO1
Lowside switch, 4A max with
internal f ly back diode.
Inductiv e load should NOT
hav e f ull time power. See Spare GPO1 Basic Setup section
of User GPIOs and PWM Setup
Wizard page LowSide Assignment
Tables f or additional options.
C2-45 UEGO 2 VM UEGO 2 VM
Bosch UEGO Controller
Virtual Ground signal. Connect to pin
5 of Bosch UEGO sensor.
C2-46 UEGO 2 UN UEGO 2 UN
Nernst Voltage signal. Connect to pin
1 of Bosch UEGO sensor.
C2-47 UEGO 2 IP UEGO 2 IP
Pumping Current signal. Connect to
pin 6 of Bosch UEGO sensor.
C2-48 UEGO 2 IA UEGO 2 IA
Trim Current signal. Connect to pin 2
of Bosch UEGO sensor.
C2-49 UEGO 2 HEAT UEGO 2 HEAT
Lowside switch f or UEGO heater
control. Connect to pin 4 of Bosch
UEGO sensor. NOTE that pin 3 of
the Sensor is heater (+) and must be
power by a f used/switched 12V
supply .
C2-50 +12V_R8C_CPU
Battery Perm
Power
Dedicated power management
CPU
Optional f ull time battery power.
MUST be powered bef ore the ignition
switch input is triggered. (See C1-65.)
C2-51 Coil 7 Coil 7 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C2-52 Coil 8 Coil 8 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C2-53 Coil 9 Coil 9 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C2-54 Coil 10 Coil 10 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C2-55
Highside Fuel
Pump switch
Fuel Pump
Highside switch, 0.7A max,
Solid State Relay , NO internal
f ly back diode. +12V High Side Driv e. Will prime f or
2 seconds at key on and activ ate if
RPM > 0.
C2-56 Not used Not used Not used Not used