Infinity supported application 19 – AEM Infinity Supported Applications - Mitsubishi 2006 Evolution IX Engine User Manual
Page 19

Infinity Supported Application
19
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware
Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest.
Pin
Evo
VIII
Dest.
Pin
Evo IX
Hardware Specification
Notes
C2-34
Analog_In_21
3 Step Enable
Switch
12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V
as this can permanently damage the
ECU. See 3StepSwitch 1-axis table
f or setup.
C2-35
Analog_In_22
USB Logging
Activ ate
12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V
as this can permanently damage the
ECU. See USBLoggingRequestIn
channel f or input state. See Setup
Wizard page USB Logging f or
conf iguration options.
C2-36
Analog_In_23
Charge Out
Pressure
12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V
as this can permanently damage the
ECU. See ChargeOutPress [kPa]
channel f or input state. See Setup
Wizard page Charge Out Pressure f or
calibration options.
C2-37
Digital_In_6
Spare Digital
Input
45
83
No pullup. Will work with TTL
signals.
Input can be assigned to dif f erent
pins. See Setup Wizard page Input
Function Assignments f or input
mapping options.
C2-38
Digital_In_7
Clutch Switch
No pullup. Will work with TTL
signals.
See ClutchSwitch 1-axis table f or
setup options. Input can be assigned
to dif f erent pins. See Setup Wizard
page Input Function Assignments f or
input mapping options.
C2-39
Power Ground
Ground
Power Ground
Connect directly to battery ground.
C2-40
Power Ground
Ground
Power Ground
Connect directly to battery ground.
C2-41
CanH_Bout
CANH
Dedicated High Speed CAN
Transceiv er
Not used
C2-42
CanL_Bout
CANL
Dedicated High Speed CAN
Transceiv er
Not used
C2-43
LowsideSwitch_8
Engine Protect
Warning Out
32
Lowside switch, 4A max with
internal f ly back diode.
Inductiv e load should NOT
hav e f ull time power.
Activ ates if any of the f ollowing
f lags are true: OilPressProtectOut,
LeanProtectOut, or CoolantProtect.
Output can be assigned to other
f unctions. See Setup Wizard page
LowSide Assignment Tables f or
additional options.