AEM Infinity Supported Applications - Mitsubishi 2006 Evolution IX Engine - Manual (Page 18)

18
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware
Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest.
Pin
Evo
VIII
Dest.
Pin
Evo IX
Hardware Specification Notes
C2-21 Analog_In_16
DBW1_TPSB
[%]
12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V
as this can permanently damage the
ECU.
C2-22 +5V_Out_2 +5V Out
Regulated, f used +5V supply
f or sensor power
Analog sensor power
C2-23 +5V_Out_2 +5V Out
Regulated, f used +5V supply
f or sensor power
Analog sensor power
C2-24 +5V_Out_2 +5V Out
Regulated, f used +5V supply
f or sensor power
Analog sensor power
C2-25 VR+_In_5
Driv en Right
Wheel Speed
Sensor +
Dif f erential Variable Reluctance
Zero Cross Detection
See Driv en Wheel Speed Calibration
in the Setup Wizard Input Function
Assignment page.
C2-26 VR-_In_5
Driv en Right
Wheel Speed
Sensor -
C2-27 VR-_In_4
Non Driv en
Right Wheel
Speed Sensor -
Dif f erential Variable Reluctance
Zero Cross Detection
See Non Driv en Wheel Speed
Calibration in the Setup Wizard Input
Function Assignment page.
C2-28 V R+_In_4
Non Driv en
Right Wheel
Speed Sensor +
C2-29 LowsideSwitch_9 Tachometer 58 45
Lowside switch, 4A max with
internal f ly back diode, 2.2K 12V
pullup. Inductiv e load should
NOT hav e f ull time power.
See Setup Wizard page Tacho f or
conf iguration options.
C2-30 AGND_2 Sensor Ground Dedicated analog ground Analog 0–5V sensor ground
C2-31 AGND_2 Sensor Ground Dedicated analog ground Analog 0–5V sensor ground
C2-32 AGND_2 Sensor Ground Dedicated analog ground Analog 0–5V sensor ground
C2-33 Analog_In_20
Spare Analog
Input
12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V
as this can permanently damage the
ECU.