AEM 30-8761 CAS Trigger Disc - Manual (Page 20)

Page 20 of 25
Figure 35: Screws for CAS shaft replaced
Reinstall bearing as shown in figure 36. Next add some grease or spray lube onto the o-
ring that came off of the star socket that goes over the bearing and lightly hammer the star
socket on a flat surface so that you are only hammering the shaft until the hole for the pin
that holds the star socket lines up as shown in figure 37. A pin punch can be used to align
the hole for the pin if it is slightly off.
Figure 36: Bearing placement on CAS shaft