AEM 30-8761 CAS Trigger Disc - Manual (Page 18)

Page 18 of 25
Figure 31 shows the shaft removed once the screws are removed. Mark the disc so
that you can identify how it was mounted for future reference. Carefully remove the
CAS disc from the sensor by rotating the disc in the direction of the large arrow
relative to the locating pin so that it will pull directly up over the pin in the direction of
the small arrow.
Figure 31: CAS disc screws and shaft removed
The original and AEM trigger discs must be aligned in the correct orientation since the
locating pin is slightly offset as shown in figure 32.
Figure 32: Comparison of original and AEM trigger discs