SkyTrak 10054 Operation Manual - Manual (Page 131)

General Maintenance
129 Model 10054 Rev. 11/03
B. Oil And Filter Change
1. Operate the engine until
warm (approximately 5
minutes).
2. Level the vehicle,raise
the boom up to approxi-
mately 20°, place the
travel select lever in (N) NEUTRAL, move neutral lock lever to
NEUTRAL LOCK
position, engage the parking brake switch and shut off the engine.
3. Place receptacle under engine oil pan drain plug (4).
4. Remove the drain plug (4) and drain the oil from the engine oil pan.
5. Allow oil to drain completely into a receptacle. Transfer the oil to a
container with a cover and label the container as used oil. Dispose
of the used oil at an approved recycling facility.
6. Unlock and open the left engine access door. Remove oil filter (5).
A strap or chain filter wrench may be required.
7. Clean filter sealing surface. Make sure the o-ring seal from the filter
comes off the sealing surface.
NOTE: The filter o-ring may stick to the filter head. Make sure the old o-ring
is removed before installing the new filter.
8. Apply a thin coat of clean engine oil to seal on new filter.
9. Install the new oil filter and hand tighten 1/2 turn after initial contact.
50
250
OS0830
OH2670
OH2710
OH3450
5