SkyTrak 10054 Operation Manual - Manual (Page 77)

Oper ati on
75
Model 10054 Rev 3/02
Attachment Reconnect
Be su re yo ua re perfo rm in gt hisp ro cedur eo nl evel grou nd.
1.P ositi onthe veh icle dire ctly behind theatta chmen tto bem ounted.
2.T ilt th eq uick attac hba ckwar d.
3.E xtend theboo map prox im ately 10 feet (3 meter s)an dd rive the
veh ic le for ward unti lt hea ttachm entpiv otpin sa re below and
betw ee nt het wo hoo kson th ea tta ch men t.
4.Ra ise th eb oomunti lthe attachm entpi vot pins have sea tedful lyin
the hook sof th eat tachme nt.
5.T ilt th ea ttachm entup slig htly .T hequi ck attac hl ink shoul db et ight
agai nst the rear ofthe attach ment andthe holes in the link and the
attac hment sho uld beal igned.
6. Plac et he trav else lect le ve rin (N )N EU TR AL, mo ve th en eutr al lo ck
le ve rt oN EU TR AL LOCK po siti on,en gage the pa rk in gb ra kes wit ch
an de xit th ev ehicl eu sing thehand holds .
7.L ift theq uick attac hl ever .Ins ert the quic katta chpi nc omple tely
thro ughthe attach ment and the quic kattac hli nk. Bes ure that the
quic ka ttach lock lev erh asl owered and seated its elfi ntothe gro ove
in the quic katta chpi n.
8.Re turn to thec ab,fas tenthe sea tbe lta ndr esu meo perat ion.
WA RNING:
DONO Top erate this ve hicle unles sy oua re in
the seat with thes eatbel tf astene dar ound you. Death ors erio us
pers ona li nju ry coul dr esul ti ft hebe lt is not se cur ely fa ste ned .
Operation
75 Model 10054 Rev 3/02
Attachment Reconnect
Be sure you are performing this procedure on level ground.
1. Position the vehicle directly behind the attachment to be mounted.
2. Tilt the quick attach backward.
3. Extend the boom approximately 10 feet (3 meters) and drive the
vehicle forward until the attachment pivot pins are below and
between the two hooks on the attachment.
4. Raise the boom until the attachment pivot pins have seated fully in
the hooks of the attachment.
5. Tilt the attachment up slightly. The quick attach link should be tight
against the rear of the attachment and the holes in the link and the
attachment should be aligned.
6. Place the travel select lever in (N) NEUTRAL, move the neutral lock
lever to NEUTRAL LOCK position, engage the parking brake switch
and exit the vehicle using the hand holds.
7. Lift the quick attach lever. Insert the quick attach pin completely
through the attachment and the quick attach link. Be sure that the
quick attach lock lever has lowered and seated itself into the groove
in the quick attach pin.
8. Return to the cab, fasten the seat belt and resume operation.
WARNING:
DO NOT operate this vehicle unless you are in
the seat with the seat belt fastened around you. Death or serious
personal injury could result if the belt is not securely fastened.