SkyTrak 10054 Operation Manual - Manual (Page 141)

Ge nera lM ain ten anc e
139
Model 10054 Rev 3/02
3.A llo wt hetr an smis sion toco ol.
4.P la ce ar ec ep tac leund erthe trans miss ion dra inplu g( Fig ure 95).
Re mo ve th edr ain plu ga nd allo wt heU niv ersa lT ra ctor Flu id to
dra in int ot her ec eptacl e.T ran sfer theus edo ilin toa suita blec on-
tain erwit ha cov era ndl abel the con tai neras used oil. Dispos eof
prop erl y.
5.Cl ean an dr e-i ns tall thedr ain plug into the tran smis sion housi ng.
6.Re move the filter fro mthe filt erm ount on the fron ts ide oft het ra ns-
mis sion (F igu re 95). Dispo seof thefi lter prope rly .Cl eanthe matin g
sur fac ew here the filt ermo unts.
7.A pply ath infil mo fc lean Univ ersa lT rac torF luid tothe new filter
gas ket .C aref ully insta lla new filte r.
Figure 95
8.Re move thed ipsti cka ndf ill with Univ ers alT ra ctor Flui da pprox i-
matel y2.6 gallo ns( 9,8 lite rs ). Re-i nstal lt hed ipsti ck
9.Ch eck the tra ns mis sio nle vel and ad dU niver sal Tra ctor Flui da s
re qu ired follo wing the proc edur esout lined in“T ra ns mis sio nO il
Lev elC heck ”o np age137 .
10.Re asse mble th etr ansm iss ionco vers an ds ecur ei np lace withthe
six ca ps crew so rh exnu ts ,w ashe rsan dl ockw as he rs. Tigh te n
secu rely .
OH2 380
Transmis sion
Dra in Plu g
Tran smi ssi on
Filter
Tran smissi on
Dipstick andFill
General Maintenance
139 Model 10054 Rev 3/02
3. Allow the transmission to cool.
4. Place a receptacle under the transmission drain plug (Figure 95).
Remove the drain plug and allow the Universal Tractor Fluid to
drain into the receptacle. Transfer the used oil into a suitable con-
tainer with a cover and label the container as used oil. Dispose of
properly.
5. Clean and re-install the drain plug into the transmission housing.
6. Remove the filter from the filter mount on the front side of the trans-
mission (Figure 95). Dispose of the filter properly. Clean the mating
surface where the filter mounts.
7. Apply a thin film of clean Universal Tractor Fluid to the new filter
gasket. Carefully install a new filter.
Figure 95
8. Remove the dipstick and fill with Universal Tractor Fluid approxi-
mately 2.6 gallons (9,8 liters). Re-install the dipstick
9. Check the transmission level and add Universal Tractor Fluid as
required following the procedures outlined in “Transmission Oil
Level Check” on page 137.
10. Reassemble the transmission covers and secure in place with the
six capscrews or hex nuts, washers and lockwashers. Tighten
securely.
OH2380
Transmission
Drain Plug
Transmission
Filter
Transmission
Dipstick and Fill