SkyTrak 10054 Operation Manual - Manual (Page 181)

TestProcedures
179
Model 10054 Rev 3/02
Stabil -TRA KSy stem TestP roce dures
Step 1:
a. Pla ce the ve hicle ona le vel sur fa cewit h0 °s wa y .
b. Hav eth ebo omf ully re trac tedand horiz ontal .
c. Pla ce an8 "( 203 mm) woo dor cem entb loc ki nf ro nto fthe front
left tire .
d. Ente rt hev ehic le .
e. Fa sten these atb elt .
f. T ur nthe ke yto theR UN pos itio n.
g. Chec kt obe sur et heSta bil- TRAK ligh tis OF F .( See page 39f or
the loc ation of theli ght inthe displ ay panel.)
Step 2:
a. Star tt heeng ine.
b. T ur nt he pa rki ngbr ake sw itc hO FF.
c. Mo ve ther ange sele ctle ve rt o( 1)F IRST ge ar.
d. Mo ve thetr avel sele ctle ve rt ot he (F )F ORW ARDpos ition .
e. Driv et hev ehi cle upon the bloc k.
f. Use the frame sw ay con tro lt ol evel thev ehic le bac kt o0° .
Step 3:
a. Depr ess thes erv ic ebr ake pedal .
b. Mo ve thetr avel se lec tle ve rt ot he (N)N EUTRAL posit ion.
c. Rais et he boom toe xac tly6 0°. Th eS tabi l-T RA Kl ig ht sho uld
com eO Nwhe nthe boom angle isat abou t40° andr emai nO N.
WA RNING:
DONO Top erate this ve hicle unles sy oua re in
the seat with thes eatbel tf astene dar ound you. Ser ious inj ury or
death coul dr esul tif thebel ti sn ots ec ure ly fa ste ned.
Test Procedures
179 Model 10054 Rev 3/02
Stabil-TRAK System Test Procedures
Step 1:
a. Place the vehicle on a level surface with 0° sway.
b. Have the boom fully retracted and horizontal.
c. Place an 8" (203 mm) wood or cement block in front of the front
left tire.
d. Enter the vehicle.
e. Fasten the seat belt.
f. Turn the key to the RUN position.
g. Check to be sure the Stabil-TRAK light is OFF. (See page 39 for
the location of the light in the display panel.)
Step 2:
a. Start the engine.
b. Turn the parking brake switch OFF.
c. Move the range select lever to (1) FIRST gear.
d. Move the travel select lever to the (F) FORWARD position.
e. Drive the vehicle up on the block.
f. Use the frame sway control to level the vehicle back to 0°.
Step 3:
a. Depress the service brake pedal.
b. Move the travel select lever to the (N) NEUTRAL position.
c. Raise the boom to exactly 60°. The Stabil-TRAK light should
come ON when the boom angle is at about 40° and remain ON.
WARNING:
DO NOT operate this vehicle unless you are in
the seat with the seat belt fastened around you. Serious injury or
death could result if the belt is not securely fastened.