BNC 645 - Manual (Page 69)

69
DIGital:PATTern:TRIGger:SLOPe {POS, NEG}
Set the Trigger slope of the pattern to be a positive (rising) edge or a
negative (falling) edge.
DIGital:PATTern:TRIGger:SLOPe?
Inquire and gain the trigger slope status of the pattern.
DIGital:PATTern:OUTPut:TRIGger {OFF, ON}
Set the trigger of the pattern out to be ON or OFF.
DIGital:PATTern:OUTPut:TRIGger?
Inquire or gain the trigger status of the pattern out.
DIGital:PATTern:OUTPut:TRIGger:SLOPe {POS, NEG}
Set the Trigger slope of the pattern out to be a positive (rising) edge or
a negative (falling) edge.
DIGital:PATTern:OUTPut:TRIGger:SLOPe?
Inquire and gain the trigger slope status of the pattern out in positive
(rising) or negative (falling) edge.
DATA:PATTERN VOLATILE,
Download binary values into volatile memory. You can download from 1
to 262144 (256K) points per waveform in IEEE-488.2 binary block
format.
Socket pin out structure
Pattern Generator Cable
The 40-pin cable is used to connector the socket and you board or
device.