BNC 645 - Manual (Page 103)

103
the maximum value allowed with the specified offset voltage.
-221 Settings conflict; low level changed due to high level
The high level must always be greater than the low level. If you
specify a high level that is smaller than the low level, the waveform
generator will adjust the low level to be 1 mV less than the high level.
-221 Settings conflict; high level changed due to low level
The high level must always be greater than the low level. If you
specify a low level that is greater than the high level, the waveform
generator will adjust the high level to be 1 mV greater than the low
level.
-222 Data out of range; value clipped to upper limit
The specified parameter is out of range and is adjusted to the
maximum value allowed.
-222 Data out of range; value clipped to lower limit
The specified parameter is out of range and is adjusted to the
minimum value allowed.
-222 Data out of range; pulse edge time limited by period; value
clipped to upper limit
The specified edge time does not conform within the existing period
and is adjusted to the maximum value allowed.
-222 Data out of range; pulse width time limited by period; value
clipped to…
The specified pulse width does not conform to the following condition
and is adjusted to accommodate the period:
PulseWidth ≤ Period – (1.6 x EdgeTime)
-222 Data out of range; pulse duty cycle limited by period; value
clipped to…
The specified duty cycle does not conform to the following condition
and is adjusted to accommodate the period:
DutyCycle ≤ (1 – 1.6 x Edge time / Period) x 100%