BNC 835 Programmer Manual User Manual
Programmer’s manual v1.4, Signal generator models
This manual is related to the following products:
Table of contents
Document Outline
- WARRANTY
- Berkeley Nucleonics Corporation warrants all instruments, including component parts, to be free from defects in material and workmanship, under normal use and service for a period of one year. If repairs are required during the warranty period, conta...
- IMPORTANT! PLEASE READ CAREFULLY
- NOTIFICATION OF COPYRIGHT
- THE FIRMWARE IN THIS DEVICE IS PROTECTED BY COPYRIGHT LAWS AND INTERNATIONAL TREATY. YOU MUST TREAT THE FIRMWARE LIKE ANY OTHER COPYRIGHTED MATERIAL. COPYRIGHT LAWS PROHIBIT MAKING ADDITIONAL COPIES OF THE FIRMWARE FOR ANY REASON OTHER THAN SPECIFIC...
- Table of Contents
- 1 Introduction
- 2 Programming the instrument
- 3 IEEE-488 Interface Commands
- 4 SCPI Commands
- 5 SCPI Command Description
- 5.1 :ABORt Subsystem
- 5.2 :INITiate Subsystem
- 5.3 :OUTPut Subsystem
- 5.4 [SOURce]:FREQuency Subsystem
- 5.5 [SOURce]:CHIRp Subsystem
- 5.6 [SOURce]:PHASe Subsystem
- 5.7 [SOURce]:POWer Subsystem
- 5.8 [SOURce]:CORRection Subsystem
- 5.9 [SOURce]:ROSCillator Subsystem
- 5.10 [SOURce]:LIST Subsystem
- 5.11 [SOURce]:LFOutput Subsystem
- 5.12 [SOURce]:SWEep Subsystem
- 5.13 [SOURce]:AM Subsystem (Amplitude Modulation)
- 5.14 [SOURce]:FM Subsystem (Frequency Modulation)
- 5.15 [SOURce]:PM Subsystem (Phase Modulation)
- 5.16 [SOURce]:PULM Subsystem (Pulse Modulation)
- 5.17 [SOURce]:ILS Subsystem
- 5.18 [SOURce]:VOR Subsystem
- 5.19 :TRIGger Subsystem
- 5.20 :STATus Subsystem
- 5.21 :SYSTem Subsystem
- 5.22 [:SYSTem:COMMunicate] Subsystem
- 5.23 UNIT Subsystem