BNC 835 Programmer Manual - Manual (Page 47)

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
5.14 [SOURce]:FM Subsystem (Frequency Modulation)
8
Command Parameters Unit (default)
[SOURce:]FM:DEViation 1000 Hz
[SOURce:]FM:SENSitivity 1000 Hz/V
[SOURce:]FM:INT:FREQuency 400 Hz
[SOURce:]FM:INTernal:SHAPe RD|RU|SINE|SQUare|TRIangle SINE
[SOURce:]FM:SOURce INTernal | EXTernal EXT
[SOURce:]FM:STATe ON|OFF|1|0 OFF
[SOURce:]FM:COUPling DC | AC AC
:FM:DEViation
[SOURce]:FM:SENSitivity
[SOURce]:FM: SENSitivity?
This command sets the frequency modulation deviation. This setting will be used if :FM:SOURce is set
to LFGenerator.
The variable is expressed in units of Hertz.
*RST 1000
:FM:SENSitivity
[SOURce]:FM:SENSitivity
[SOURce]:FM: SENSitivity?
This command sets the frequency modulation deviation per one volt peak amplitude signal input. This
setting will be used if :FM:SOURce is set to EXTernal.
The variable is expressed in units of Hertz per Volt.
*RST 1000
:FM:INT:FREQuency
[SOURce]:FM:INT:FREQuency
[SOURce]:FM:INT:FREQuency?
This command sets the frequency modulation rate in Hz. This setting will be used if :FM:SOURce is
set to INTernal.
The variable is expressed in Hertz.
*RST 400
:FM:INT:SHAPe
[SOURce]:FM:INT:SHAPe RD|RU|SINE|SQUare|TRIangle
[SOURce]:FM:INT:SHAPe?
This command specifies the FM modulation shape. RD selects Ramp-Down and RU ramp up.
Standard waveforms available are SINE, SQUare and TRIangle.