12 [source]:sweep subsystem, Sour, Ubsystem – BNC 835 Programmer Manual User Manual
Page 43: Source]:sweep subsystem
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
5.12
[SOURce]:SWEep Subsystem
Command
Parameters
Unit (default)
Remark
[SOURce]:SWEep:COUNt
INFinite|
INFinite
[SOURce]:SWEep:DIRection
UP|DOWN|RANDom
UP
[SOURce]:SWEep:POINts
2 to 65535
[SOURce]:SWEep:DWELl
s
[SOURce]:SWEep:DELay
s
[SOURce]:SWEep:DELay:AUTO
ON|OFF|1|0
ON
[SOURce]:SWEep:PROGress?
[SOURce]:SWEep:SPACing
LINear|LOGarithmic
[SOURce]:FREQuency:MODE
FIXed|CW|SWEep|LIST
[SOURce]:FREQuency:STARt
fmin to fmax
Hz
[SOURce]:FREQuency:STOP
fmin to fmax
Hz
[SOURce]:POWer:MODE
FIXed|LIST|SWEep
[SOURce]:POWer:STARt
dBm
[SOURce]:POWer:STOP
dBm :SWEep:COUNt INFinite | [SOURce]:SWEep:COUNt Infinite | [SOURce]:SWEep:COUNt? This command sets the number of sweep repetitions being played after triggering a sweep. If set to INFinite, the sweep will be repeated until a [SOURce]:FREQuency:MODE or [SOURce]:POWer:MODE command is issued. *RST INFinite Range INFinite or 2-65535 :SWEep:DIRection UP|DOWN|RANDom [SOURce]:SWEep:DIRection UP | DOWN | RANDom :SWEep:POINts [SOURce]:SWEep:POINts [SOURce]:SWEep:POINts? This command defines the number of step sweep points. *RST 101 Range 2–65535 :SWEep:DWELl [SOURce]:SWEep:DWELl