BNC 835 Programmer Manual - Manual (Page 48)

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
:FM:SOURce
[SOURce]:FM:SOURce EXTernal | INTernal
[SOURce]:FM:SOURce?
This command selects the FM modulation signal source. If INTernal is selected, an internal modulation
source is applied. If EXTernal is selected, the device’s M input (a t the re a r pa
*RST EXT
:FM:STATe
[SOURce]:FM:STATe ON|OFF|1|0
[SOURce]:FM:STATe?
This command turns the frequency modulation on or off.
*RST OFF
:FM::COUPling
[SOURce:]FM:COUPling DC | AC
[SOURce:]FM:COUPling?
This command selects to signal coupling for the external FM modulation.
*RST AC