BNC 835 Programmer Manual - Manual (Page 14)

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
3.1.7 *OPT?
The options (OPT) query returns a comma-separated list of all currently installed instrument options on
the signal generator.
Returned option strings are:
0
Basic device
B3 Rechargeable battery pack
PE|PE2|PE3 Extended power range
AVIO ILS and VOR modulations
GPIB GPIB (IEEE 488) programming interface
3.1.8 *RCL
The Recall (RCL) command recalls the state from the specified memory register .
3.1.9 *RST
The Reset (RST) command resets most signal generator functions to factory- defined conditions.
Remarks Each command shows the [*RST] default value if the setting is affected.
3.1.10 *SAV
The Save (SAV) command saves signal generator settings to the specified memory register .
Remarks The save function does not save all signal generator settings. Refer to the User’s Guide for
more information on the save function.
3.1.11 *SRE
The Service Request Enable (SRE) command sets the value of the Service Request Enable Register.
The variable is the decimal sum of the bits that will be enabled. Bit 6 (value 64) is ignored and
cannot be set by this command.
Range 0–255
The setting enabled by this command is not affected by signal generator preset or
*RST. However, cycling the signal generator power will reset it to zero.
3.1.12 *SRE?
The Service Request Enable (SRE) query returns the value of the Service Request Enable Register.
Range 0–63 & 128-191