10 [source]:list subsystem, Sour, List – BNC 835 Programmer Manual User Manual
Page 37: Ubsystem, Source]:list subsystem

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
5.10
[SOURce]:LIST Subsystem
Command
Parameters
Unit
(default)
Remark
[SOURce]:LIST:COUNt
INFinite |
INFinite
[SOURce]:LIST:DIRection
UP|DOWN|RANDom
UP
[SOURce]:LIST:DWELl
s
[SOURce]:LIST:DELay
s
[SOURce]:LIST:DELay:AUTO
ON|OFF|1|0
ON
[SOURce]:LIST:FREQuency:POINts?
[SOURce]:LIST:FREQuency
Hz
[SOURce]:LIST:MANual
[SOURce]:LIST:MODE
AUTO | MANual
[SOURce]:LIST:POWer
dBm
[SOURce]:LIST:POWer:POINts?
[SOURce]:LIST:PROGress?
MEMory:FILE:LIST?
FIRSt|LAST|NEXT|PREVious
MEMory:FILE:LIST:DATA
{<”filename”>},
MEMory:FILE:LIST:DELete
<”filename”>|ALL
MEMory:FILE:LIST:LOAD
<”filename”>
MEMory:FILE:LIST:STORe
<”filename”>
:LIST:COUNt INFinite |
[SOURce]:LIST:COUNt INFinite |
[SOURce]:LIST:COUNt?
This command sets the number of list repetitions being played after triggering a list sweep. If set to
INFinite, the list sweep will be repeated until a [SOURce]:FREQuency:MODE or
[SOURce]:POWer:MODE command is issued.
*RST INFinite
Range INFinite or 2-65535
:LIST:DIRection
[SOURce]:LIST:DIRection UP|DOWN|RANDom
[SOURce]:LIST:DIRection?
This command sets the direction of a list or step sweep. UP This choice enables a sweep in an
ascending order:
• first to last point for a list sweep
• start to stop for a step sweep
DOWN This choice reverses the direction of the sweep.