BNC 835 Programmer Manual - Manual (Page 22)

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
5 SCPI Command Description
5.1 : ABORt Subsystem
The :ABORt command is a single command subsystem. There are no subcommands or associated
data parameters, as shown below. The :ABORt command, along with the :TRIGger and :INITiate
commands, comprise the Trigger group of commands.
Command Parameters Unit
(default)
Remark
:ABORt
:ABORt
:ABORt
This command causes the List or Step sweep in progress to abort. Even if INIT:CONT[:ALL] is set to
ON, the sweep will not immediately re-initiate.