ARB 5650010 - Manual (Page 6)

PRE - ASSEMBLY OF REAR BAR
3. INSTALLATION OF THE SLIDER
Insert two plastic square plugs into holes in
the rear bar. The plugs should snap into the
square holes as shown.
Fasten the slider to the rear bar using the
two black self-tapping screws provided.
NOTE: - Place the tapered face of the slider
towards the front face of the rear bar as
shown in the photo.
4. INSTALLATION OF THE CATCH HOOK
Fasten the catch hook to the rear bar as
shown.
Use the M8 x 25 mm bolts, spring washers
and panel washers supplied.
Make these bolts finger tight only at this
stage.
They will be tightened after the wheel
carrier has been adjusted.
Last Rev Date: 16/10/2006 Page 6 of 25 3783210 - rev 3
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd