ARB 5650010 - Manual (Page 20)

FITTING THE WHEEL MOUNTING BRACKET TO THE CARRIER
2.
INSTALLATION OF THE STUDS
TO THE BRACKET
Using a steel vice or similar place the
stud through the appropriate holes.
NOTE: - 5 x 4½” has two studs at the
top and one in the bottom.
Using a large hammer hit the back of
the stud until it is fully bottomed out
as shown.
Once all three studs are installed it will
look like the example shown above in
step 1 .
3.
WHEEL MOUNTING BRACKET
COMPONENTS
Fit two M12 cage nuts (long leg) to the
wheel mount bracket as shown.
NOTE: The body of the cage nuts
should be on the inside of the channel
as shown.
4. WHEEL MOUNTING BRACKET TO
CARRIER
Slide the wheel mount bracket into the
wheel carrier as shown in the photo.
Using the M12 bolts, spring washer
and body washer bolt the wheel mount
bracket to the wheel carrier both sides.
Do not fully tighten these bolts, as the
bracket must now be adjusted.
Top of bracket
M12 Caged
nuts
(long leg)
Last Rev Date: 16/10/2006 Page 20 of 25 3783210 - rev 3
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd