Gradall LOED 534A Service Manual - Manual (Page 80)

Insert two of the capscrews with washers
installed into opposite holes and torque
to 175 lbs. ft.
Using a 10" wrench, check to see if
the drive shaft will turn. Shaft will be
tight but should turn freely with a max-
imum of 5 to 10 lbs. torque.
If shaft will not turn as stated, dis-
assemble the pump and examine for
burrs or foreign material causing build-
u p o r i n t e r f e r e n c e i n t h e p a r t s .
Remove the cause and reassemble as
b e f o r e .
When shaft turns properly, tighten the
remaining nuts and torque to 175 lbs.
f t . e a c h .
REASSEMBLY
35.
36.
37.
38.
39.
80
FIGURE 139