Gradall LOED 534A Service Manual User Manual
Page 62
Take cover plate (23) and place it
on a clean flat surface with the
o-ring groove facing up. Install
o-ring (20). (SPM20 only)
Place the motor body (4) on the
cover plate (SPM20) with the
gear bore facing up. Make sure
that the mark made in, Step 2 is
facing you. (If a new body is
used, it does not matter which way
the body faces.) (Fig. 91)
REASSEMBLY
27.
28
.
29
.
Install center separator (16), end
separator (15) and sealing strip
(17). (No separators in SPM25)
(Fig. 93)
Install the o-rings (35), then the
back-up rings (14 on the bearings
which extend up from the bottom of
the body. (Fig. 92)
30.
62
FIGURE 91
FIGURE 92
FIGURE 93