Gradall LOED 534A Service Manual - Manual (Page 66)

Lay the partially assembled unit on
its side and install studs (43),
washers (22) and nuts (21). You can
wait until the motor is completely
assembled before applying final
torque to these studs. (Fig. 102)
Position the assembly with the valve
body up and install o-ring (34) and
spline coupling (31). Make sure the
gears are not turned from the
timing position until after the
other set of gears has been assembled.
(Fig. 103)
Install motor body (2) with the mark
that was made in Step 2 facing you
and with the gear bore facing up.
(Fig. 104)
Repeat (as applicable) Steps 29
through 38. Make sure that Step 31
is followed closely.
42.
43.
44.
41.
66
FIGURE 103
FIGURE 101
FIGURE 102
FIGURE 104