Gradall LOED 534A Service Manual User Manual
Page 57
Clean the outside of the motor
thoroughly.
Mark the motor sections on the
drive shaft extension side so
that they can be reassembled
exactly in the same order as
they were originally. (Fig. 74)
Securely fasten the motor in a
machinist’s vise, shaft up. Use
a cream block of wood between each
flat side of the motor and the
vise jaws. This will protect the
machined surfaces from damage which
would cause leakage at port
connectors. (Fig. 75)
D I S A S S E M B LY
Remove nuts (21) and washers (22)
from the flange. (Fig. 76)
1.
2.
3.
4.
57
FIGURE 74
FIGURE 75
FIGURE 76