Gradall LOED 534A Service Manual - Manual (Page 60)

Remove the valve body by tapping
lightly on the plugs (39) with a soft
hammer. (Fig 87)
Remove o-ring (34).
To disassemble the rear motor sec-
tions, repeat Steps 7 through 12,
as applicable. Keep these parts
separate from the front motor.
Although most of the parts are inter-
changeable, the body and gears may
not be. (Fig. 88)
15.
16.
17.
18.
19.
20.
21.
60
FIGURE 85
FIGURE 87
FIGURE 86 FIGURE 88
To disassemble the rear section, it
will be necessary to reverse its
position in the vise (rear end up).
(Fig. 85)
Remove nut (21) and washer (22).
Remove cover plate (23), o-ring (20)
(some SPM20 only), and stud bolts
(43)
Now remove the assembly from the
vise and set it on a clean bench
with the valve body (3) up. (Fig. 86)