Gradall LOED 534A Service Manual User Manual
Loed material handler, Model 534a service manual
LOED MATERIAL HANDLER
MODEL 534A
Service Manual
PART NO. 9020-5896
®
IMPORTANT
READ AND UNDERSTAND THIS MANUAL
BEFORE STARTING, OPERATING OR
PERFORMING MAINTENANCE PROCEDURES
ON THIS MACHINE.
KEEP THESE MANUAL IN CAB
Gradall is a registered trademark for hudraulic
excavators built by The Gradall Co.
THE
COMPANY
406 MILL AVENUE S.W.
NEW PHILADELPHIA, OHIO 44663
(216) 339-2211
This manual describes the LOED Handler as origionally
designed and built by the LOED Corporation. The LOED
Handler product line was purchased October 15, 1982 by
The Warner & Swasey Co., a subsidiary of The Bendix
Corporation. Descriptions and specifications shown herein
are subject to change without notice.
Table of contents
Document Outline
- 90205896 534A LOED Service Manual
- Table of Contents
- General Information
- Service & Replacement P arts
- Capacity
- Nomenclature
- Retraction Chain Replacement
- Extension Chain Replacement
- Boom Hose Replacement
- Shift Control Linkage Adjustment
- Brake Adjustment
- Tire & Rim Servicing Safety
- Parking Brake Repair
- Power Brake Master Cylinder Repair
- Planetary Hub Repair
- Hydraulic Pressure Checks
- Hydraulic Cylinder Repair
- Valve Repair
- Pump & Motor Troubleshooting
- Pump Repair
- Rear Drive Motor Repair
- Front Drive Motor Repair (Before S/N 237)
- Bolt Torque Chart
- Hydraulic Fitting Torque Chart
- Electrical Schematics
- Hydraulic Schematics
- Hydraulic Component Location