Gradall LOED 534A Service Manual User Manual
Page 51
33.
40.
39.
38.
51
FIGURE 61
FIGURE 63
FIGURE 62
FIGURE 64
34.
35.
36.
37.
Install the spline coupling (16) and
O-ring (25). (Figure 61)
Install dowels (20).
Install body (1) with identifying
mark made in Step 2 facing you, and
with gear bore up
.
To assemble this pumping section,
repeat Steps 23 through 31, using
gears 7 and 5.
Install dowels (20) in body (1).
(Figure 62)
Install and tighten stud bolts.
(Figure 63)
If a new flange plate (4) is used,
plug (27) will have to be pressed
into seal drain hole on the dis-
charge side of the flange plate.
(Figure 64)
For seal replacement, refer to seal
assembly section in this manual.