Gradall LOED 534A Service Manual - Manual (Page 70)

Position the new seal over the bore
with the rubber lip entering first.
Center a press ring (or a socket
wrench of appropriate size) against
the metal back of the seal and close
the vise against it. Carefully
tighten the vise and press the seal
into bore until it seats against
the shoulder in the bore. (Fig. 111) 7.
70
Install the snap ring, making sure
it snaps into the groove properly.
(Fig. 112) 8.
Wash the flange in clean solvent,
blow it dry and coat the seal lips
with clean grease. 9.
Install a new o-ring in the flange
p l a t e o - r i n g g r o o v e a n d t h e p l a t e
s h o u l d b e r e a d y t o b e r e i n s t a l l e d
on the motor. 10.
FIGURE 110
FIGURE 111
FIGURE 112