OR-Fab 84204 ROCKER PANEL (PAIR) TJL (UNLIMITED) - Manual (Page 6)

6 Jeep TJ, TJL Rocker Panels
3. Driver rivet nut(s)
a. Install kit rivet nut into 3/8” hole(s) on side of
body with kit washer (1/4” SAE), kit nut (5/16”),
and kit bolt (1/4” x 1-1/4”) as shown.
b. Keeping kit rivet nut firmly against body, hold kit
nut (5/16”) and tighten kit bolt (1/4” x 1-1/4”)
until kit rivet nut is secure in 3/8” hole(s).
NOTE
TJL Models: DO NOT install kit rivet nut into drilled 3/
8” hole on bottom of body channel.
3/8” Hole
Kit Rivet Nut,
Kit Washer
(1/4” SAE),
Kit Nut
(5/16”),
Kit Bolt
(1/4” x 1-1/4”)
Install Kit Rivet Nut
Into Body
FRONT
*
TJ MODELS
TJL MODELS
Install Kit Rivet Nuts
Into Body
*TJ Models: Install ONLY if this
hole in BODY drilled to 3/8” !!!
Body
Kit Nut
(5/16”)
Kit Bolt
(1/4” x 1-1/4”)
c. Remove kit bolt (1/4” x 1-1/4”), kit washer (1/4”
SAE), and kit nut (5/16”).
d. Repeat above substeps for passenger rivet
nut(s).
4. Driver rocker panel
a. Install kit hangar (slotted) and kit bolt (3/8” x 2”
carriage) into rear body channel hole.
Kit Washer
(1/4” SAE),
Kit Nut
(5/16”)
Kit Bolt
(1/4” x 1-1/4”)
Kit Rivet Nut
Body Channel
Hole
Kit Hangar
(Slotted),
Kit Bolt
(3/8” x 2”
Carriage)
INSTALLED