OR-Fab 85209 JEEP WRANGLER JK SWING AWAY SPARE TIRE CARRIER WITH ROTOPAX CONTAINERS User Manual
Before starting installation, Tools needed
3651 N Highway 89 • Chino Valley, AZ 86323
(928) 636-7080 • www.orfab.com
JEEP WRANGLER JK
SWING-A-WAY TIRE/CAN CARRIER
WITH ROTOPAX 3 GALLON CANS
2007-2012 JK
Kits # 85209
NOTE
These instructions are for both the can and non-can
style carriers. Installation of both systems are identical
with the only difference being the shape of the main
carrier itself. All pictures in these instructions refer-
ence the Tire/Can carrier model.
WARNING
Read and understand all instructions, warnings, cau-
tions, and notes in this sheet and in your owners man-
ual before you begin the installation of this tire/tire-can
carrier kit.
CAUTION
Proper installation of a ORFab tire carrier kit requires
knowledge of the factory recommended procedures for
disassembly and assembly of original equipment com-
ponents. We recommend that the factory shop manual
and any special tools necessary to your vehicle be on
hand during the installation. Installation of this tire car-
rier lift kit without proper knowledge of the factory rec-
ommended procedures may affect the performance of
these components and the safety of your vehicle. We
strongly recommend that a certified mechanic familiar
with the installation of similar components install this
tire carrier kit.
ROTOPAX Swing-Away Tire/Can Carrier w/Gas Cans
1
Kit # 85209
Before starting installation
1. Carefully read all warnings and instructions com-
pletely before beginning.
2. Verify all parts have been received in this kit by
checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is
specified. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.
4. Park the vehicle on a clean, dry, flat, level surface
and block the tires so the vehicle cannot roll in either
direction.
Tools needed:
1. Angle Drill
2. 1” hole saw OR Unibit 335
WARNING
The load rating for these tire-can/tire carriers is a
MAXIMUM of 175 lbs. Please be aware that some tire
and wheel combinations along with gas cans and hi-lift
jacks can exceed this MAXIMUM rating.
WARNING
Some states require a center high-mount stop lamp by
law. OR Fab recommends that you consult your state
laws before you install this kit. If required you’ll need
optional (CHMSL) kit# 87017.
NOTE
Kit parts are prefaced by the word kit and appear in
bold print.