OR-Fab 87041 00-06 TOYOTA TUNDRA / 01-07 SEQUOIA TRANS. SKID PLATE/CAT THEFT SHIELD - Manual

3651 N Highway 89 • Chino Valley, AZ 86323
(928) 636-7080 • www.p-a-g.net
2000-2006
TOYOTA TUNDRA / SEQUOIA
TRANSMISSION SKID PLATE &
CAT THEFT DETERRENT SHIELD
INSTALLATION INSTRUCTIONS
KIT# 87041
WARNING
Before you install this kit, read and understand all
instructions, warnings, cautions, and notes in this
instruction sheet and in the vehicle owner’s manual.
CAUTION
Proper installation of this kit requires knowledge of the
factory recommended procedures for removal and
installation of original equipment components. We rec-
ommend that the factory shop manual and any special
tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper
knowledge of the factory recommended procedures
may affect the performance of these components and
the safety of the vehicle. We strongly recommend that
a certified mechanic familiar with the installation of sim-
ilar components install this kit.
WARNING
Always wear eye protection when operating power
tools.
WARNING
Before you install this kit, block the vehicle tires to pre-
vent the vehicle from rolling.
Toyota Transmission Skid & Cat Theft Deterrent 1 Kit #87041
Before Starting Installation
1. Carefully read all warnings and instructions com-
pletely before beginning.
NOTE
Kit parts are prefaced by the word kit and appear in
bold print.
2. Verify all parts have been received in this kit by
checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is
specified. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.
4. Park vehicle on a clean, dry, flat, level surface and
block tires so vehicle cannot roll in either direction.
Prepare to Install Skid Plate
1. Install kit nut plates
a. Locate all four of your mounting holes.
b. Install two kit 3/8” nut plates into each large
hole opening in transmission cross member.
NOTE
If parts are missing from kit, please be prepared to pro-
vide the following information:
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
5. Inspector # from inside box cover
Locate Skid Mounting Holes
Transmission
Cross Member Kit Nut Plate