OR-Fab 87031 ROTOPAX FUEL CAN CARRIER ADAPTER BRACKET KIT - Manual

3651 N Highway 89 • Chino Valley, AZ 86323
(928) 636-7080 • www.p-a-g.net
ROTOPAX FUEL CAN CARRIER
ADAPTER BRACKET
INSTALLATION INSTRUCTIONS
Kit # 87031
WARNING
Read and understand all instructions, warnings, cau-
tions, and notes in this sheet and in your owners man-
ual before you begin the installation of this coil lift kit.
WARNING
Use extreme caution when working near fuel contain-
ers. Clean up spilled fuel immediately. Any spark
could cause an explosion or fire resulting in serious
personal injury and property damage.
1 ROTOPAX Fuel Can Carrier - Kit 87031
A. Before Installation.
1. Read all warnings and instructions completely and
carefully before you begin.
2. Check to make sure the kit is complete (refer to the
Parts List, Section C).
3. Only install this kit on the vehicle for which it is
intended. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.
B. Fuel Can Carrier Installation
1. Assemble fuel can carrier.
a. Install the fuel can carrier assembly to the ORF
Tire/Fuel Can Carrier. Position lip of lower
mounting bracket into the bracket on the tire/fuel
can carrier.
b. Install the button head bolt in the upper hole of
the fuel can carrier bracket.
c. Install the Rotopax mount #RX-PM using four
provided kit hardware 1/4”-20 x 1” carrage bolt
and 1/4” flange nut onto the center of the ORF
Tire/Fuel Can Carrier adapter bracket.
NOTE
Kit parts are prefaced by the word kit in italics.
Kit Lower
Mounting
Bracket
Bracket
ORF Tire/
Fuel Can
Carrier.
Fuel Can
Carrier
Bracket
Button
Head Bolt
ORF Tire/
Fuel Can
Carrier.
Kit Fuel Can
Carrier
Bracket
ORF Carrier
Kit 1/4-20x1”
Carrage Bolt
Flange Nuts
Rotopax Mount
# RX-PM
3651 N. Hwy 89 • Chino Valley, AZ 86323
(928) 636-7080 • www.p-a-g.net