OR-Fab 87013 JEEP FUEL CAN ADAPTER KIT FOR NON-LIP GAS CAN - Manual

3651 N Highway 89 • Chino Valley, AZ 86323
(928) 636-7080 • www.p-a-g.net
NON-LIP FUEL CAN CARRIER
INSTALLATION INSTRUCTIONS
Kit # 87013
WARNING
Read and understand all instructions, warnings, cau-
tions, and notes in this sheet and in your owners man-
ual before you begin the installation of this coil lift kit.
WARNING
Use extreme caution when working near fuel contain-
ers. Clean up spilled fuel immediately. Any spark
could cause an explosion or fire resulting in serious
personal injury and property damage.
1 Non-Lip Fuel Can Carrier - Kit 87013
A. Before Installation.
1. Read all warnings and instructions completely and
carefully before you begin.
2. Check to make sure the kit is complete (refer to the
Parts List, Section C).
3. Only install this kit on the vehicle for which it is
intended. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.
B. Fuel Can Carrier Installation
1. Assemble fuel can carrier.
a. Install the kit lower mounting bracket to the kit
fuel can carrier bracket with two kit 1/4” - 20 x 1”
carriage bolts and two kit 1/4” - 20 flange nuts.
Do not tighten.
NOTE
Kit parts are prefaced by the word kit in italics.
Kit Fuel Can
Carrier
Bracket
Kit Lower
Mounting
Bracket Kit Carriage
Bolts, Nuts