OR-Fab 87022 Winch Mounting Plate -- Fits OR-Fab Rock Slider Non-Winch Front Bumpers for Jeep JKs User Manual

OR-Fab For the car

3651 N Highway 89 • Chino Valley, AZ 86323

(928) 636-7080 • www.p-a-g.net

JEEP WRANGLER JK
RUBICON / UNLIMITED
WINCH MOUNTING PLATE
2007 - 2012

Kit # 87022

WARNING

Read and understand all instructions, warnings,
cautions, and notes in this sheet and in your owners
manual before you begin the installation kit.

Winch Mounting Plate #87022

A. Before Installation

1. Read all warnings and instructions completely and

carefully before you begin.

2. Check to make sure the kit is complete (refer to the

Parts List at the end of this document).

3. Only install this kit on the vehicle for which it is

intended. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.

B. Get ready to install kit

1. Prepare the light bracket for installation.

a. Position kit Winch Mounting Plate centered on

topside of bumper. Be sure to use a streight
edge or fairlead on kit Winch Mounting Plate
allowing the fairlead to mount flush against the
front face of the bumper.

b. Using the kit Winch Mounting Plate as your

template, mark the four outside ears for drilling.
Use 1/2” drill bit & drill your marked holes.

Once kit Winch Mounting Plate is in position
and fairlead is flush with face of bumper; Mark
the four inside holes for your winch using the kit
Winch Mounting Plate as a template.

d. Check the size of your winch mounting

hardware(provided with your winch) and use
appropriate size drill bit to drill your inside holes.

e. Install kit Winch Mounting Plate using provided

kit 1/2” hardware. Center and tighten all kit
bolts.

Set your winch on top of kit Winch Mounting
Plate and use your provided winch mounting
hardware to mount your winch. (NOTE: It maybe
neccessary to purchase longer hardware for
your winch to mount properly through the kit
Winch Mounting Plate and bumper.)

C. Parts List

Quantity

Description

Bolt, 1/2” x 1”

Nut, 1/2” Flange

Washer, 1/2” SAE

NOTE

Kit parts are *ONLY* to be used with OR-Fab bumper:
83204 / 83212 / 83224 OEM Fog Light Bumpers

Performance Automotive Group