OR-Fab 83100 ROCK SLIDER REAR BUMPER CJ / TJ / TJL - Manual

3651 N Highway 89 • Chino Valley, AZ 86323
(928) 636-7080 • www.p-a-g.net
JEEP WRANGLER /
RUBICON (TJ / YJ)
JEEP UNLIMITED (TJL)
ROCK SLIDER REAR BUMPER
INSTALLATION INSTRUCTIONS
1987-2006
KIT # 83100
WARNING
Read and understand all instructions, warnings, cau-
tions, and notes in this sheet and in your owner’s man-
ual before you install this kit.
WARNING
The Jeep Wrangler is rated as a Class I tow vehicle.
See owner’s manual. The kit bumper is equipped with
a 2” receiver for vehicle recovery purposes. The kit
bumper is NOT rated for towing.
1 Jeep Rock Slider Rear Bumper - Kit 83100
Before starting installation
1. Carefully read all warnings and instructions com-
pletely before beginning.
2. Verify all parts have been received in this kit by
checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is
specified. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.
4. Park the vehicle on a clean, dry, flat, level surface
and block the tires so the vehicle cannot roll in either
direction.
Install kit
1. Stock bumper
a. Remove bolts securing stock bumper to bottom
of frame. If equipped with tow hooks, remove
additional bolts and tow hooks.
b. Remove four nuts and stock bumper from frame.
NOTE
Kit parts are prefaced by the word kit and appear in
bold print.
Bolts
Tow Hook
With Tow Hook
Without Tow Hook
Frame
Frame
Bolt
Stock
Bumper
Stock
Bumper
Stud, Nut