beautypg.com

OR-Fab 84320 ROCKER SIDE ARMOR WRANGLER JK 4-DOOR User Manual

Before starting installation

background image

3651 N Highway 89 • Chino Valley, AZ 86323

(928) 636-7080 • www.p-a-g.net

JEEP WRANGLER,
RUBICON, UNLIMITED (JK)
ROCKER SIDE ARMOR KIT
INSTALLATION INSTRUCTIONS

KIT# 84310

2007-2012 JK 2 - DOOR

KIT# 84320

2007-2012 JK 4 - DOOR

WARNING

Before you install this kit, read and understand all
instructions, warnings, cautions, and notes in this
instruction sheet and in the vehicle owner’s manual.

CAUTION

Proper installation of this kit requires knowledge of the
factory recommended procedures for removal and
installation of original equipment components. We rec-
ommend that the factory shop manual and any special
tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper
knowledge of the factory recommended procedures
may affect the performance of these components and
the safety of the vehicle. We strongly recommend that
a certified mechanic familiar with the installation of sim-
ilar components install this kit.

WARNING

Always wear eye protection when operating power
tools.

WARNING

Before you install this kit, block the vehicle tires to pre-
vent the vehicle from rolling.

1

JEEP JK Rocker Armor Kit

Before Starting Installation

1. Carefully read all warnings and instructions com-

pletely before beginning.

2. Verify all parts have been received in this kit by

checking the parts list at the end of this document.

3. Only install this kit on the vehicle for which it is

specified. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.

4. Special tools needed:

a. Drill with 5/16” and 3/8” drill bits

b. 21/64” center punch

5. Park vehicle on a clean, dry, flat, level surface and

block tires so vehicle cannot roll in either direction.

Engine Compartment

1. Disconnect both battery cables. Disconnect nega-

tive cable first, then positive cable.

NOTE

Kit parts are prefaced by the word kit and appear in
bold print.

NOTE

If parts are missing from kit, please be prepared to pro-
vide the following information:

1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
5. Inspector # from inside box cover

This manual is related to the following products: