OR-Fab 84204 ROCKER PANEL (PAIR) TJL (UNLIMITED) - Manual (Page 4)

4 Jeep TJ, TJL Rocker Panels
d. Remove kit rocker panel (driver) and measure
2-1/2” and 5-1/2” rearward from scribed line and
scribe two parallel lines as shown.
e. Remove push clip and cut rear plastic fender
well along scribed lines indicated below.
f. Using a hydraulic floor jack or other brace, posi-
tion kit rocker panel (driver) onto body. Ensure
kit rocker panel mates flush against body.
g. Align two slots with front drain plug hole and rear
body channel hole. Secure kit rocker panel
(driver) to body with c-clamps or locking pliers.
Mark
Body
Channel
Plastic
Fender Well
2-1/2”
5-1/2”
Cut Along
Lines
Push
Clip
h. Using 21/64” center punch, mark seven body
mount holes and one lower body channel hole.
i. Remove kit rocker panel (driver) from vehicle.
j. Drill three 3/8” holes into body and bottom of
body channel as indicated below.
k. Drill five 5/16” holes into body as indicated
below.
l. Repeat above substeps for passenger rocker
panel.
Body
21/64”
Center Punch
Kit Rocker
Panel
FRONT
Drill 3/8” Holes
Into Body
FRONT
Drill 3/8” Holes Here
Into Body Channel
Drill 5/16” Holes Into Body
FRONT