Brady 300X-PLUS - Manual (Page 27)

Printing a Test Label
To print a test label:
1. Turn off the printer.
2. Press and hold the CANCEL key
while turning on the printer.
A configuration label, which shows the
printer’s currently stored parameters,
will print (similar to the one shown in
Figure 12).
If you encounter any problems while you are configuring or calibrating the
printer or printing a test label, refer to Troubleshooting, which starts on
page 75. Otherwise, refer to Establishing Communication on page 21 to set
up the communication parameters.
Brady X-PLUS Series User’s Guide 19
Figure 12