Brother FAX-565 - Manual (Page 27)

1 - 10 INTRODUCTION
Connections
The external TAD must be plugged into the back side of the fax machine, into the
jack labeled EXT. The fax machine cannot work properly if you plug the TAD into a
wall jack (unless you are using Distinctive Ring).
1
Plug the telephone line cord from the wall jack into the back side of the fax
machine, in the jack labeled LINE.
2
Plug the telephone line cord from your external TAD into the back side of the
fax machine, in the jack labeled EXT. (Make sure this cord is connected to the
TAD at the TAD’s telephone line jack, and not its telephone set jack.)
3
Set your external TAD to four rings or less. (The fax machine’s Ring Delay
setting does not apply.)
4
Record the outgoing message on your external TAD.
5
Set the TAD to answer calls.
6
Set the Receive Mode to TAD:ANSWER MACH.
(See Choosing the Receive Mode on page 5-1.)
Do not connect a TAD elsewhere on the same phone line (unless you have
the Distinctive Ring service).
TAD
TAD