B&B Electronics EIR505-XX - Manual (Page 48)

38
Manual Documentation Number: EIR505-xx_5107m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Per Port Configuration
Configure path cost and priority of every port
1. Select the port in Port column
2. Path Cost: The cost of the path to the other bridge from this transmitting
bridge at the specified port. Enter a number 1 through 200000000
3. Priority: Network Priority. Enter a number from 0 to 240. The value must
be a multiple of 16
4. Admin P2P: Some of the rapid state transactions that are possible
within RSTP are dependent upon whether the port concerned can only
be connected to one other bridge (i.e. it is served by a point-to-point LAN
segment), or whether it can be connected to two or more bridges (i.e. it
is served by a shared medium LAN segment). This function allows the
P2P status of the link to be manipulated administratively. True is P2P
enabling. False is P2P disabling
5. Admin Edge: The port directly connected to end stations cannot create
a bridging loop. To configure the port as an edge port, set the port to
“True” status
6. Admin Non Stp: The port includes the STP mathematic calculation.
True does not include the STP mathematic calculation. False includes
the STP mathematic calculation
7. Click Apply
[NOTE] If the configuration is not saved, it will be lost when the switch
is powered off.