beautypg.com

B&B Electronics EIR610 Series User Manual

Quick start guide, Elinx managed ethernet switch eir610 series, Items included

background image

EIR610 Series-5107qsg

International Headquarters: 707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA

815-433-5100 Fax 433-5104

www.bb-elec.com

[email protected]

[email protected]

European Headquarters: Westlink Commercial Park Oranmore Co. Galway Ireland

+353 91 792444 Fax +353 91 792445

www.bb-europe

.com [email protected] [email protected]

Quick Start Guide

Elinx Managed Ethernet Switch

EIR610 Series

Items Included

1

2

3

LED Chart

Hardware Installation

Log into the Switch

5

4













o

Ethernet Switch

o

Console Cable (RS-232 RJ-45 to DB-9)

o

CD with Support Manual

o

This Quick Start Guide

o

Panel Mount Bracket



o

IP Address: 192.168.16.1

o

Subnet Mask: 255.255.255.0

o

Gateway: 192.168.16.254

o

User Name: root, Password: root



LED Status

Meaning

Green

The Switch is powered on

PWR

Off

The Switch is powered off

Green

Power Source 1 is available

PWR1

Off

Power Source 1 is unavailable

Green

Power Source 2 is available

PWR2

Off

Power source 2 is unavailable

Red

Power or Port failure

Fault

Off Normal

Operation

Green

The Switch is the master of a redundant
ring (X-Ring)

R.M

Off

The Switch is not the master of a
redundant ring.

Green

SFP Port is linked

Blinking

Data is being transmitted or received

LINK/ACT

P7/9/10

*

SFP

Off

Not connected to the network

T Green Port

is

linked

T Blinking

Data is being transmitted or received

T Off

Not connected to the network

B Green

Operating at 1000M

Port

7/9/10*

RJ-45

B Off

Disconnected or below 1000M

T Green

Connected to the network

T Blinking

Data is being transmitted or received

T Off

Not connected to the network

B Yellow

Operating in full-duplex

B Blinking Data

collision

P1-6/8

*

B Off

Half-duplex or not connected

*Note

EIR610-3SFP: Ports 1-6 and 8 are 10/100 RJ-45, Ports
7, 9, and 10 are 100/1000 RJ-45 or SFP.






o

Record the switch’s MAC Address in the space
provided. The MAC Address is printed on the product
label. NOTE: Provide the MAC Address to your
Network Administrator. The Network Administrator
should provide an IP Address, Subnet Mask, and
Gateway.

o

Select a mounting location and install with the attached
DIN rail clip or included panel mount kit.

o

Connect power to the switch

o

12 to 48 VDC

o

Redundant inputs are available with fault
contacts.

NOTE: The installation of an SFP Module disables
the associated RJ-45 Port.

o

These instructions are for Web based management.
Refer to the User’s Manual for instructions concerning
console management.

o

Connect a switch port to a stand alone PC. Change the
PC’s network IP Address to allow it to connect to the
switch (ex: 192.168.16.2). Use the default subnet mask
and gateway.

o

Launch the PC’s web browser and navigate to the
switch by typing the switch’s IP Address in the browser
address window.

o

Navigate the web page by expanding the folders on the
left side of the web page.





Default Settings

This manual is related to the following products: