Brother DCP-9010CN User Manual
Page 66
58
Print Unable XX
The machine has a mechanical
problem.
Do one of the following:
Disconnect the machine from the power
for several minutes, then reconnect it.
If the problem continues, call your
Brother dealer.
Print Unable 1A
One of the issues that can cause
this error is that condensation
may form inside the machine after
a room temperature change.
Turn the power switch off and fully open the
top cover. Leave the machine off and open
for 30 minutes to remove any condensation
from inside the machine, then close the top
cover and turn the machine on again. If this
does not clear the error, call your dealer or a
Brother Customer Service.
Registration
Registration failed.
Press Mono Start or Colour Start and try
again.
Do one of the following:
Turn off the machine’s power switch.
Wait a few seconds, then turn it on again.
Try Manual Registration, Menu, 3, 7.
(See Manual Registration on page 76.)
Put in a new belt unit. (See Replacing the
belt unit on page 89.)
If the problem continues, call your
Brother dealer.
Replace Belt
It is time to replace the belt unit.
Replace the belt unit. (See Replacing the
belt unit on page 89.)
Replace Drums
It is time to replace the drum
units.
Replace the drum units.
(See Replacing the drum units on page 86.)
The drum unit counter was not
reset when a new drum was
installed.
Reset the drum unit counter.
(See Resetting the drum counter
on page 89.)
Replace Drum(X)
It is time to replace the drum unit
for the indicated colour.
Replace the drum unit for the colour
indicated on the LCD.
(See Replacing the drum units on page 86.)
Replace Fuser
It is time to replace the fuser unit. Call your Brother dealer to replace the fuser
unit.
Replace PF Kit
It is time to replace the paper
feeding kit.
Call your Brother dealer to replace the PF
Kit.
Replace Toner
The toner cartridge is at the end
of its life.
Replace the toner cartridge for the colour
indicated on the LCD. (See Replacing a
Toner cartridge on page 79.)
Replace WT Box
It is time to replace the waste
toner box.
Replace the waste toner box. (See
Replacing the waste toner box on page 93.)
Error Message
Cause
Action