Brother DCP-9010CN - Manual (Page 65)

Troubleshooting and routine maintenance
57
C
Init Unable XX The machine has a mechanical
problem. Do one of the following:
„ Disconnect the machine from the power
for several minutes, then reconnect it.
„ If the problem continues, call your
Brother dealer.
Jam Inside The paper is jammed inside the
machine. (See Paper jams on page 61.)
Jam Rear The paper is jammed in the back
of the machine. (See Paper jams on page 61.)
Jam Tray The paper is jammed in the paper
tray of the machine. (See Paper jams on page 61.)
No Belt Unit The belt unit is not installed
correctly. Re-install the belt unit. (See Replacing the
belt unit on page 89.)
No Paper The machine is out of paper or
paper is not correctly loaded in
the paper tray. Do one of the following:
„ Refill the paper in the paper tray and
press Mono Start or Colour Start or put
the paper in the manual feed slot.
„ Remove the paper and load it again.
Then press Mono Start or Colour Start.
„ If the problem is not solved, the paper
pick-up roller may be stained. Clean the
paper pickup roller. (See Cleaning the
paper pick-up rollers on page 75.)
No Toner The toner cartridge or the drum
unit and toner cartridge assembly
is not installed correctly. Re-install the toner cartridge or the drum unit
that is indicated on the LCD.
No Waste Toner The waste toner box is not
installed correctly. Re-install the waste toner box. (See
Replacing the waste toner box on page 93.)
Out of Memory The machine’s memory is full. Copy operation in progress
Do one of the following:
„ Press Mono Start or Colour Start to
copy the scanned pages.
„ Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
„ Clear the data from the memory. (See
Out of memory message on page 32.)
Print operation in process
Reduce print resolution. (See Advanced tab
in the Software User’s Guide on the
CD-ROM.)
Error Message Cause Action